Lumastream Trinity 12 Analog Manual do Utilizador descarregar pdf (Página 2)

Trinity 12 Analog Speciﬁcations

Input

Output

System Protection

Safety and EMI/EMC

Environmental

Control Interface

Rated Input Voltage 115 to 277 Vac hard wired ; 115 to 125 Vac power cord

Rated Input Frequency 47 - 63 Hz

Power Factor EN61000-3-2 @ 115 Vac, 100% load, 0.97 W/VA min

Input Current Total Harmonic Distortion @ 115 Vac, 100% load, 13% max

Rated Output Power @ 40°C / 104°F ambient, 243 W max

Output Voltage 66 series: 6 to 27 Vdc; 70 series: 12 to 47 Vdc

Efciency 87% with 100% load @ 115 Vac input

System Power Cycle Delay 2 second typical time required for stabilization of all outputs

Output Current Tolerance +/-5 % of nominal

Output Over voltage, over current, short circuit protection

Over Temperature Power supply will shut down when external ambient temperature

exceeds 43°C/ 109.4°F or case temperature reaches 85°C/ 185°F

nominal.

Output Interconnection Hiccup mode with automatic recovery upon removal of short. Only

applies to +ve to -ve interconnections.

Agency Approvals UL 8750 Class 2 outputs

Conducted and Radiated Emissions ICES-003; FCC Title 47, Part 15, Class A (for commercial use only)

EN61000-3-2 Harmonics Emissions, Class C

EN61000-4-4 Electrical Fast Transient, 1KV Criteria B

EN61000-4-5 Surge, 2KV Criteria B

EN61000-4-11 Voltage Dips, Interruptions, and Voltage Variations, according to

EN61547

Location Rating Dry

Operating Ambient Temperature -20°C to 40°C / -4°F to 104°F

Cold Start Temperature -20°C / -4°F

Storage Ambient Temperature -40°C to 80°C / -40°F to 176°F

Relative Humidity 5% to 95% noncondensing

Mean Time Between Failure

(MIL HDBK-217F); (12 channel)

>60,000 hours @ 40°C / 104°F; >97,000 hours @ 25°C / 77°F

Control Method Analog 0-10 Vdc, IEC 60929 Annex E Outputs 0.5 mA max or variable

0-10 Vdc Voltage Source; Class 2 outputs.

Control Zones Master control: simultaneous control of all the output channels.

Zonal control: up to 12 independently congurable output channels.

Loss of Analog Input Signal Outputs will go to 0% or 100% light intensity in less than 1 second; must

set default valve, 0% or 100%

LSPS08 / Trinity 12 Analog 12 Zone

1 2 3

Comentários a estes Manuais

Sem comentários

Lumastream Trinity 12 Analog Manual do Utilizador Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com Iluminação Lumastream Trinity 12 Analog